Audio Developments AD146 - Manual (Page 19)

18
S-switch (15) - creates a matrix amplifier across an adjacent pair of input modules.
Refer to M-S NOTES.
The panoramic potentiometer (7) routes the signal proportionately between
A and/or C outputs (L) and B and/or D outputs (R). Routeing switches (8) are
independent of each other and also act as channel mutes.
The monitor 1 path is the true output from the module (independent of any other
routeing) and is derived from the output of the panpot - and S-switch (15) if selected.
MON (16) routes the channel signal to monitor 1 module and is auditioned when
CH (1) is selected. This monitor 1 output also automatically appears on monitor 2
(headphones) output. MON can also be used as an AFL (after-fader listen) function,
ie to monitor the mono output of the module. In this case, select MON (16), and CH
(1) and MONO (14) on the monitor module.
SIP (solo-in-place) usage of MON is
outlined in the MONITOR MODULE section.
PFL (9) routes the signal at the fader input to monitor 2, ie the headphones-
output jack. PFL overrides any other signal appearing on monitor 2.
The Penny & Giles fader (17) is calibrated 10dB down from its fully open position,
allowing the operator to work with 10dB of gain in reserve. Faders on adjacent
modules can be coupled for stereo operation by the use of standard ganging clips.
(The fader may be calibrated at its fully open position if desired - and the scale
changed accordingly.)