AudioEngine A2+ POWERED DESKTOP SPEAKERS - Manual (Page 7)

A2+ setup guide 10 11
Step 4 - Enjoying your Speakers
1. Turn on the rear panel volume/power knob and set the
volume control to about 3 o’clock.
2. Turn on your audio source and adjust the volume to your
desired listening level.
Two audio sources may be connected to the speakers at the
same time. To adjust the volume, we recommend using the
individual volume controls on each source.
We recommend using a high-quality surge suppressor and/or AC
line filter on all electronics equipment.
Basic Troubleshooting
If the LED indicator on the power supply is not illuminated:
- Check to see that the power cord is securely connected to the
power supply and to an AC power outlet.
- Check that the AC power outlet is supplying power.
If the speakers do not produce sound:
- Check that the cable from the power supply is connected to
the rear panel, and that the LED indicator on the power supply is
illuminated.
- Check that the volume/power knob on the rear panel is not set
to minimum volume or powered off (we recommend at least a
10 o’clock position).
- Check that the volume level of your audio source in not set to
minimum or powered off.
- Check that the wire from your audio source to your speakers
is properly connected (occasionally the 1/8” cable feels as if it is
inserted all the way, but is not).
If the speakers produce sound from the left speaker but not the
right:
- Check that the speaker wires are correctly connected between
the left and right speaker connectors.
- Check that the cable from your audio source to the speakers is