AudioEngine D1 24-BIT DAC - Manual (Page 6)

D1 setup guide 8 9
Troubleshooting
• I have connected my D1 as shown in the manual, but there is no
music output.
1. Check to see that the power light is lit. If not, try another USB
output on your computer.
2. Ensure that D1 is selected as your output device under Control
Panel (PC) or System Preferences/Audio (Mac).
3. Try another USB cable.
• I have connected my D1 to my TV/DVD/BluRay, but there is no sound
output.
1. Be sure that D1 is also connected to a USB power adapter, and
that the power light is lit.
2. Be sure that your TV/DVD/BluRay digital audio is set to “PCM
Stereo”.
• Only one channel plays through my D1.
1. Check the RCA cables between your D1 and your sound system.
2. Check your audio player to ensure that the balance is centered.
Break-In Period
Your DAC will sound great out of the box and will get better over time.
However, give it 40 to 50 hours break-in time before doing any critical
listening.
Specifications
Electrical
Full Scale output
2.0V RMS
Frequency Response 10 Hz - 25 kHz, +/- 0.5db
S/N Ratio (DC to 20 kHz) >110 dB
THD+N (1 kHz FS 96 kS/s) <0.0025%
Interface
Input Data Rate
up to 192KS/s
Input Bit Depth up to 24 bits
USB type 1.1 or above
Power Requirements 130 mA
For additional specifications go to: audioengineusa.com