Autocue SSP17 V2 - Manual (Page 2)

Assembly
1. Fix the hot shoe from your
tripod to the underside of the
mounting plate. Slide the hot
shoe to the approximate
position and tighten the
screws.
Components
A
Hood and
Glass
B
Monitor
C
Mounting
Plate
D
Hood
Adjustment
D
C
A
B
2. Mount the unit on the
tripod.
Mounting the Camera
10. It is important that the camera lens is in the centre
of the aperture at the rear of the hood.
This is achieved by raising and lowering the camera
mounting plate and hood.
Glass Installation
3. Remove the three
thumb screws that secure
the hood frame and
open the hood.
4. Place the glass in the
hood and ensure that
the glass is located in
the recess.
5. The glass is installed with
the blue dot facing up. A
double image will be seen
in the reflection if the glass
is not installed correctly.
6. Close the hood and
replace the three thumb
screws and secure.
Please ensure that the
glass is in the recess or the
glass may be damaged.
7. The glass is now
Installed.
9. The Hood is
now locked in
the upright
position.
8. Raise the hood and lock it
in the upright position by
tightening the four thumb
screws.