Autocue MSP12 Master Series Teleprompter - Manual (Page 2)

On-Camera Unit Assembly
A Rods
B
Rod
Adjustment
Clamp
C
Balance
Adjustment
Lever
D
Keyhole
Locking Disc
E
3/8” BSW
Fixing Hole
F
1/4” BSW
Fixing Hole
G
Camera
Screw
Components
A
B
C
D
G
F
E
1. Remove the hot shoe
from your tripod head
and fix it to the under-
side of the Pro Plate
ideally using both 1/4”
and 3/8” BSW fixing
screws.
2. Replace the Pro Plate on
the tripod head ensuring that
the keyhole locking discs are
facing forward.
3. Mount the hood and
bracket set onto the rods
using the keyhole mounting
holes.
4. Ensure that the bracket
set is secured in position
by tightening the keyhole
locking disc.
5. Mount the camera using the camera screw, access the
screw from the under side of the plate (
G ). Please ensure
that the lens is in the centre of the aperture on the back
of the hood. To adjust the height of the hood loosen the
tube clamps, adjust to the desired height and retighten
to secure. The hood and bracket assembly can be
moved forwards or backwards by loosening the rod
adjustment clamp, once in the desired position retighten
to secure.
6. If needed the height of the entire bracket assembly
can be adjusted by using the notched slots in the key
hole plate. Three positions are available. To move the
plate loosen the three knobs and move the plate to
the desired height then retighten the knobs.