Autocue SSP07 User Guide - Manual (Page 2)

Assembly
A
B
C
D
E
G
F
1. Remove the unit from its case
and carefully place the glass
side face down, onto a level
surface.
2. Loosen the thumbscrews holding the monitor
mounting plate and raise the monitor.
3. Align the metal tongue of the monitor mounting
plate with the slot in the drop bracket and carefully
insert the tongue into the slot. (fig. i)
4. Tighten the thumbscrews to secure the monitor
mounting plate. (fig. ii)
5. Attach the tripod camera mounting plate
to the hot shoe plate on the underside of
the SSP07 unit.
6. Slide the on-camera
unit onto your tripod.
7. Loosen the two thumbscrews
holding the monitor mounting plate
and hood assembly.
8. Raise the hood assembly to
the vertical position and tighten
the thumbscrews.
9. Rotate the camera bracket so that it is on the
top of the unit and behind the hood.
Components
10. Fix your camera to the bracket using the
camera screw. Slot the bracket over the
thumbscrews and tighten all four thumbscrews to
secure it.
A Hood and glass
B Monitor
C Hood Bracket
D Camera Bracket
E Hot Shoe Plate
F Drop Bracket
G Monitor
mounting plate
H Hood
thumbscrew
I Hood Slide
Screw
fig. i fig. ii
H Vertical position
I
11. Attach the large plug
to the socket on the side
of the monitor.
12. You can use either a
composite or VGA video
input by connecting the
appropriate cable.
VGA (using
adaptor cable)
Video
Power 12V DC