Autocue USB Controller For Use With QPro - Manual

Configuring The New DLP 2-button USB Controller For Use With QPro
Step 1: Installing the driver
A) Install the driver here:
ftp://ftp.autocue.com/Drivers/Windows_DLP_Drivers.exe
B) Plug the controller into the PC and open the Windows device manager.
-This can be found on Windows XP under Start, Settings, Control Panel, System, Hardware tab
-Windows 7: press start and type “Device Man” and enter to select Device Manager in Windows
-Windows 8: press start then click to filter by “Settings” and type “Device Man” there and you will see it to click.
C) In the picture below you can see I have determined that the controller is using COMM 3.
Note: in some cases the driver will not load automatically. If this is the case and you have an unrecognized device in
Windows try a different USB port. If still no joy right-click on the unrecognized device and select to update driver. Then
pick the extracted contents of this zip file
here .