Autocue On-Camera Unit - Manual

On-Camera Unit Quick Assembly Instructions
www.qtv.com 1 www.autocue.com
Issue
#
: 080
612
©
2003
-200
8
Au
to
cu
e Grou
p Ltd
N OTE : Full assembly instructions for your specific On-Camera Unit can be found on the CD that accompanied the equipment or
from either of the web sites shown at the bottom of the page.
Introduction
All Autocue/QTV on-camera units (OCUs) comprise four components. An example is illustrated below:
All brackets attach to Autocue/QTV mounting plates using the same method.
All hoods and monitors are secured using common screw tube-clamps.
1. Hood and Glass Assembly
Autocue/QTV produces three sizes of hood and
glass: small, medium and large wide-angle.
N OTE : Small OCUs—which comprise a small wide-
angle hood, small bracket and 5-, 8- or 10-inch
monitor—are delivered pre-assembled.
Large and medium wide-angle hoods are delivered flat-
packed and will require assembly.
1. Ensure that you have the required components:
2. Open the side panels of the hood and fold the flaps over
the black metal frame.
3. Secure a side panel flap with four of the supplied M3
screws.
Repeat for the opposite flap.
N OTE : The medium hood requires fewer screws.
4. Push the threaded pins of the lower Glass Retaining Strip
through the holes in the wide-angle hood frame and
secure in position with the supplied Screw Posts.
Ensure the retaining strip is on the inside of the hood as
illustrated.
5. Remove the large screw from a tube clamp and position
the clamp so that the locating pin aligns with the small
hole adjacent to the tube clamp screw hole in the metal
frame.
1. Bracket (attaches to the
mounting plate to hold the
hood and monitor in front of
the camera)
2. Hood and reflective glass
3. Mounting Plate and
Telescopic Rods attach the
prompter to the tripod/
pedestal
4. Monitor
- hood body
- glass panel
- glass retaining bar
- locking clamps
- screws
Locating pin
Pin hole