Autocue 22" Talent Feedback Monitor - Manual (Page 10)

10
Adjustment Procedure
1. Adjust by <VGA>sub menu in the OSD Menu.
To automatically adjust the clock, phase, screen position and resolution.
Note:
The Auto sizing function is intended for use on the computer running Windows. It may
not work properly when the computer is running on MS-DOS (Not windows) or the
background color for the "wall paper" or "desktop" pattern is set to black.
If the appropriate screen cannot be made by using the Auto adjustment button,
adjust the screen through the following procedures.
2. Adjust by using <VGA>sub menu in the OSD Menu.
(1) Vertical bars appear on the screen
→ Use the <Clock> adjustment.
Select the <Clock> and eliminate the vertical bars by using the UP and Down of the
Control buttons.
Do not continuously press the Control buttons, as the adjustment value will change
quickly and make it difficult to locate the most suitable adjustment point. If the
horizontal flickering, blur or bars appear, proceed to <Phase> adjustment as follows.
(2) Horizontal bars appear on the screen.
→ Use the <Phase> adjustment.
Select the <Phase> and eliminate the horizontal flickering, blurring or bars by using
the Right and Left buttons.
Note: Horizontal bars may not completely disappear from the screen depending on
the computer.
(3) The screen position is incorrect.
→
Use the <H-Position> or <V-Position> adjustment.
The <H-Position> or <V-Position> adjustment moves the image to the correct
position. Select <Position> and adjust the position by using the Up and Down buttons.
If vertical bars of distortion appear after finishing the <H-Position> or <V-Position>
adjustment, return to <Clock> adjustment and repeat the previously explained
adjustment procedure. (Clock Phase
→ → <H-Position> or <V-Position>)