Balboa Water Group Slimline Press Fit Escutcheon - Manual

Slimline Press Fit Escutcheon
Installation Instructions
Insert the rubber O’ring #2 into the Slimline wall fitting #1. 1.
Place the Slimline eyeball #3 on top of the O’ring #2. 2.
Place the poly spacer #4 on top of the eyeball #3. 3.
Center the Slimline escutcheon plate #5 over the face of the Slimline wall fitting #1, and tighten 4.
until snug.
Press metal escutcheon #6 firmly over plastic escutcheon plate #5.
5.
Caution: Do not use abrasive or caustic cleansers on decorative escutcheons
as they will damage the finish and void the warranty.
88-4043 Rev A July 1, 2009
Diagram:
#3
Slimline Eyeball
Slimline Wall Fitting
#1
Slimline
Escutcheon
Plate
#5
Slimline
Press Fit
Escutcheon
#6
Poly Spacer
#4
O’ring
#2