Balboa Water Group Dolphin II Spa Only - Manual (Page 3)

3
INSTALLING BATTERIES
1. On the back of the Dolphin™ II Remote,
remove the screws that hold the battery cover
in place and lift off the battery cover.
2 Obtain two (2) fully-charged AA alkaline
batteries.
Match the + and – marks on the batteries to
the + and – marks in the battery case, then
insert the new batteries.
3. Press the battery cover back into place, being
careful to align the rubber seal.
4. Replace the screws that hold the cover by
carefully starting each one without tightening
it. Once they are all started, snug up one
screw and then do the same to the screw on
the opposite side of the door. Repeat this in a
crossing pattern until all screws are snug.
Do not overtighten them. This will assure an
adequate water seal around the battery door.
5. Test the unit by pressing any mode key (LT, P1,
P2, P3 or BL).
If the batteries are inserted correctly, the LED
will blink once.
NOTE:
Whenever batteries need to be replaced, the
Dolphin will blink twice with every key press.
Simply replace the batteries and the remote will
be restored to its full functionality, complete
with your favorite settings.