Bang & Olufsen BeoVision Avant Real Flat Version (1995-2005) - User Guide - Manual (Page 12)

12
With the Video Programming via
Teletext (VPT) function in the video
tape recorder, you can use Teletext
TV listings when you preset Avant for
recording of future programmes. You
can also preset a Timer recording
manually.
If PDC/VPS (Program Delivery Control/
Video Programming System) signals
are broadcast by the current channel,
you can make sure that the
programme is recorded in full*, even
if the broadcast time is changed by
the broadcaster.
You can preset as many as eight
future recordings. You can also check
the status of all your pending
recordings by bringing up a list on
the screen.
You can, of course, start recording
the current programme immediately.
The video tape recorder will continue
recording until the tape runs out,
unless you give other instructions.
Record a programme
Preset a recording via Teletext TV
listings
You can preset a recording of a future
programme from a Teletext TV listings page.
Press to call up Teletext on the
screen
Locate the Teletext TV listings
page, as described on page 8
Press to highlight the first
programme name or start time
on the list
Press to move the cursor to the
programme you wish to record
Press at any time to exit the
process and return to Teletext
Press GO to select the
programme. The cursor changes
to show the date, the channel
number and channel name,
followed by ‘OK?‘
If this information is incorrect,
press s s or tt to move through
the information and ▲ or ▼ to
change the settings themselves
Press GO to store your preset
Timer recording. RECORD is
shown
TEXT
RECORD
▲ ▼
ss tt
STOP
GO
ss tt
▲ ▼
GO
While the TV is on… If PDC/VPS signals are not broadcast by the
current channel, your recordings are then preset
by start and stop times, and will not adapt to
broadcast delays or extensions. You will see the
times at the top of the screen when you store a
programme to be recorded.
If you want to record more programmes, you can
continue to highlight listed programmes with the
cursor.
*NOTE! The PDC/VPS option on the V.Tape Basic
setup menu must be set to On for Avant to record
a delayed or extended broadcast. Please refer to
Set your video tape recorder preferences on page
32 in the Reference book for information about
the V.Tape Basic Setup menu.