Bang & Olufsen DVD 1 - User Guide - Manual (Page 20)

20
You can connect DVD 1 to your
television via the socket panel on the
rear of DVD 1.
Please consult the User’s Guides
enclosed with externally connected
equipment to ensure that it is
connected in the proper manner.
Refer to Placement and Connections
on page 4 for more information
about how to connect DVD 1 to your
Bang & Olufsen television.
The socket panel on the rear
Overview of the rear socket panel
~ (mains)
Socket for connection to the mains.
DIGITAL OUTPUT
AUDIO L
AUDIO R
Audio signals are sent from DVD 1 to your
television via these three sockets. All three
sockets are used when you connect DVD 1 to
a Bang & Olufsen television which does not
use a 21-pin video cable. The DIGITAL OUTPUT
socket is also used when connecting DVD 1 to
any Bang & Olufsen television equipped with
a Dolby Digital module.
AV
21-pin socket for connection to the Bang &
Olufsen TV set.
DATA – Y/C – CVBS
Video signals are sent from DVD 1 to your
television via these sockets. The sockets are
used to connect DVD 1 to a Bang & Olufsen
television which does not use a 21-pin video
cable.
The switch options
CVBS
This switch setting is used when you connect
DVD 1 to an AV 9000, BeoVision LX,
BeoVision MS or BeoVision MX television.
RGB
This switch setting is used when you connect
DVD 1 to any other Bang & Olufsen television.
Y/C
This switch setting is used when you connect
DVD 1 to a BeoVision Avant 50 Hz television.
DIGITAL OUTPUT
AUDIO L
AUDIO R AV
DATA Y/C CVBS
CVBS
RGB
Y/C