Bang & Olufsen BeoLab 3 - User Guide - Manual (Page 4)

Setting up BeoLab 3
We recommend that you follow
this procedure:
– Disconnect your system from the
mains.
– Place the loudspeaker according
to the guidelines on these two
pages. For information on how
to fasten the loudspeaker to the
optional accessories, refer to the
Guide enclosed with the
accessory.
– Connect the loudspeaker and set
the SETUP switch as explained in
‘Cable connections’ (pp. 6–7).
– Set the POSITION switch to the
correct setting on each
loudspeaker. This is explained in
‘Adapt BeoLab 3 to your room’ (pp.
8–10).
– Connect the entire system to the
mains again.
Cautions
– Make sure that the loudspeaker
is placed and connected in
accordance with the instructions
in this Guide.
– Do not attempt to open the
loudspeaker. Leave such
operations to qualified service
personnel!
– The loudspeaker is designed for
indoor use in dry, domestic
environments only, and for use
within a temperature range of
10–40º C (50–105º F).
– Do not in any way block the free
movement of the speaker units,
and do not apply any force to
them, as this may result in
permanent damage!
– Do not lift the loudspeaker by
gripping the top part (the
acoustic lens).
– Do not place any items on top of
the loudspeaker.
– Do not place the loudspeaker
enclosed in, for example, a small
bookcase.
– Leave a minimum of 20 cm (8")
free space at the sides, and never
place anything directly in front of
the loudspeaker.
– Always place the loudspeaker in
an upright position.
4
The loudspeaker must be placed on either the black rubber base, a floor
stand, a table stand, or a wall bracket.