Bang & Olufsen BeoLab 3500 - User Guide - Manual (Page 10)

Adjust sound with Beo4
With the Beo4 remote control
you can adjust the sound
coming out of BeoLab 3500.
All sound levels are reset to their
original values when you switch
off BeoLab 3500 – unless you
store them permanently.
All the current sound levels,
including volume level, are
stored simultaneously.
The BeoLab 3500 sound is
adjusted independently from
your main audio or video
system.
To adjust sound volume or mute
the sound …
> Press or to adjust the sound
volume up or down.
> Press the middle of the
button to mute the sound, and
press or to restore the sound.
To adjust speaker balance …
> Press LIST repeatedly until
SPEAKER* is shown in the display.
> Press or to adjust balance
left or right.
To adjust bass, treble or
loudness …
> Press LIST repeatedly until
A.SETUP* (or V.SETUP* for a
video source) is shown in the
display.
> Press GO to be able to adjust
settings.
> Press LIST repeatedly until BASS,
TREBLE or LOUDNESS is shown
in the display.
> Press or to adjust the
setting.
> Press GO to select the setting.
To store sound settings
permanently – making a new
preset start-up sound level …
> Press LIST repeatedly until
S.STORE* is shown in the display.
> Press GO to store settings
permanently.
10
*NOTE! In order to display these
functions, you must first add them
to the Beo4 list of functions. Refer
to the chapter ‘Customising your
Beo4’ in the Beo4 Guide.