Bang & Olufsen BeoSound Ouverture - User Guide - Manual (Page 26)

> Using the tape recorder
26
Press while the tape is playing to see
the current setting
Press again to switch Dolby NR from
ON to OFF, or vice versa
Dolby NR is automatically reset to
ON during recording.
Using Dolby NR* noise reduction
Cancelling the automatic tape reverse function
The BeoSound Ouverture is equipped
with the Dolby B NR system. From the
factory, the noise reduction system is
cut in.
If you wish to change this setting, you
may do so by pressing the NR button.
The display then shows the current
setting. Press NR again to change from
ON to OFF, or vice versa.
Note: The Dolby NR system reduces the back-
ground noise on your tapes. If a tape is recorded
with the Dolby NR system cut in, the tape must
also be played back with the Dolby NR system cut
in.
The tape recorder always plays through
the entire tape (A and B side) before
stopping – that is, you don’t have to
turn the tape manually.
You can of course cancel the automatic
tape reverse function if you like, so
that only the current side will be
played (or recorded on).
To do so, you must press the AUT REV
button. The display then shows the
current setting. Press AUT REV again to
change from ON to OFF, or vice versa.
Dolby NR is cut in
Dolby NR is cut out
The automatic tape reverse function is cut in
The automatic tape reverse function is cut out
*Trademark of Dolby Laboratories Licensing Corporation.
Noise reduction system manufactured under license from
Dolby Laboratories Licensing Corporation.
Press while the tape is playing to see
the current setting
Press again to switch the automatic
tape reverse function from ON to
OFF, or vice versa
NR
NR
then
AUT REV
AUT REV
then