Bissell 16N5 - Manual (Page 5)

5
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
tool required: phillips screwdriver
1. Slide upper handle into lower handle by
pushing forward. Insert two long screws into
the holes marked with arrows and tighten
both until snug.
2. Attach hose rack by placing the rack over
the center back portion of the vacuum.
Be sure to feed the power cord through
the hole in the center of the rack. Line up
both screws holes and use the two smaller
screws to attach. Tighten both until snug.
3. Attach hose by placing the tabbed end into
the lower left opening on corded side of the
vacuum. Make sure the tab on the hose cuff
and the hole in the vacuum line up. Place
the working end of the hose into the hole on
the side with the extension wand guides.
4. Arrange the hose so it lays between the
vacuum and the rack.
5. Store the TurboBrush on the front of the handle
by aligning the slot on the bottom with the tab
on the handle. Snap into place.
6. Store the Combination Brush in the slot shown.
7. Make sure the crevice tool is inside the
extension wand. Store tools on vacuum as
shown.
A
ssembly
caUtIoN:
Do not plug in your
vacuum cleaner until
you are familiar with
all instructions and
operating procedures.
1 2a
3
5
6-7
2b
Telescoping
Extension
Wand