Bunn DUAL GPR-DBC WITH SMART FUNNEL 41343 - Manual (Page 26)

Page 26
PROGRAMMING FUNCTIONS - (cont.)
41343 043012
DRIP TIME (now displayed on "non" funnel lock
units as well)
This function allows the setting or modification
of the funnel locks to stay engaged after the end of a
brew cycle. This ensures the funnel cannot be removed
until after the liquid has emptied out of the funnel.
Procedure to modify drip times:
Range: OFF to 10 minutes for all three batch sizes.
NOTE: If the brewer is already in the DRIP TIMES
screen, it is not necessary to follow steps 1 through
9 in this section, but proceed directly to step 10.
1. Press and hold the upper right hidden switch until
the display reads UNITS. Release the switch. Press
and release switch until the display reads REVIEW
RECIPES.
2. Press YES to proceed. The display should now
read:
NO NAME, along with MODIFY, SHOW and NEXT
(SINGLE brewers)
NO-NAME LEFT, along with MODIFY, SHOW and
NEXT (DUAL brewers).
3. Press and release NEXT to advance to the desired
coffee name to be modified.
4. Press and release MODIFY. The display should
read BREW OZ.
5. Press and release DONE. The display should read
3 BATCHES DONE?.
6. Press and release YES. The display should now
read % BYPASS.
7. Press and release DONE. The display should read
3 BATCHES DONE?.
8. Press and release YES. The display should now
read SET PULSE BREW.
9. Press and release NO. The display should now read
DRIP TIME, along with either the word OFF, or a
time will be showing. A batch light should also be
blinking.
10. Using the (-) and (+), set the amount of time from
when the brew solenoid shuts off to when drip-out
occurs for that batch size.
NOTE: Set to OFF to prevent funnel locks from engaging
(to disable this function), for a particular batch size. To
set to OFF, press and release (-) until OFF is displayed.
11. When finished, press another batch size and repeat
step 10 until all three sizes are set.
12. When finished, press DONE. The display should
read 3 BATCHES DONE?
13. If the three batch sizes are set correctly, press YES.
The screen should show the name of the coffee
flavor being programmed (modified) along with
SETUP COMPLETE.
14. After a 5 second delay, the display will advance to
the next coffee name in the brewer's memory. If
no other coffee names are present, the display will
read THAT WAS THE LAST RECIPE, and return to
the REVIEW RECIPES screen.
REVIEW RECIPES?
NO YES
EXIT TO
NEXT FUNCTION
SCREEN
NO-NAME LEFT
MODIFY SHOW NEXT
NO-NAME
MODIFY SHOW NEXT
DUAL
BREWERS
SINGLE
BREWERS
(COFFEE NAME)
MODIFY SHOW NEXT
THAT WAS THE
LAST RECIPE
WHEN THE LAST COFFEE
NAME IN BREWER'S MEMORY
IS DISPLAYED, PRESSING
NEXT WILL EXIT AND THE
DISPLAY WILL THEN READ:
ADVANCES TO ALL OTHER
COFFEE NAMES PROGRAMMED
IN THE BREWER"S MEMORY
SCREEN DISPLAYED PRESS
BREW OZ: XX.XX DONE
3 BATCHES DONE? YES
% BYPASS XX.X DONE
3 BATCHES DONE? YES
SET PULSE BREW? NO
DRIP TIME XX.X
(-) DONE (+)
3 BATCHES DONE?
NO YES
COFFEE NAME
SETUP COMPLETE
EXITS TO THE NEXT COF-
FEE NAME IN BREWER'S
MEMORY. IF NO OTHER COF-
FEE NAMES ARE ENTERED IN
THE BREWER"S MEMORY, THE
DISPLAY WILL THEN READ: