Brother, Brother & Sons Ledonardo2 Ver. 2 - Manual (Page 7)

A
B
USER MANUAL
6
LEDONARDO 2
WWW.BROTHERS-SONS.DK
Unscrew the four screws as illustrated and remove the lamp
section.
1
2
With the lamp socket lifted, loosen the two Umbaco screws
and remove the cable from the socket.
Loosen the ground wire by removing the screw.
The socket is no longer needed and we are ready to start
mounting the LED Light Engine.
3
Using a screwdriver, remove the four locking rings on the guide
bar.
Slide the guide bar out and lift up the lampsocket / reflector
part. Be carefull not to loose the locking rings as you will
need them later.
NOTE:
The guide bar is not symmetrical, so it is recommended to mark
one end, to make sure that you remount it correctly.
Not doing so will affect the optical system.
As a rule the distance between the locking rings is smaller at
the front (A) and larger in the back (B).