Operating instructions, Curing your smoker lighting instructions – Brinkmann OUTDOOR GAS COOKER User Manual

Page 10

Advertising
background image

OPERATING INSTRUCTIONS

PLACE THE SMOKER OUTDOORS ON A HARD, LEVEL, NON-COMBUSTIBLE SURFACE AWAY FROM ROOF

OVERHANG OR ANY COMBUSTIBLE MATERIAL. PLACE THE SMOKER AWAY FROM OPEN WINDOWS OR DOORS TO

PREVENT SMOKE FROM ENTERING YOUR HOUSE. IN WINDY WEATHER, PLACE THE SMOKER IN AN OUTDOOR

AREA THAT IS PROTECTED FROM THE WIND.

GAS LEAK TESTING PROCEDURE MUST BE PERFORMED EVERY TIME THE TANK IS CONNECTED TO SMOKER.

READ ALL WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE OPERATING YOUR SMOKER.

Prior to first use, cure your smoker to minimize damage to the exterior
finish as well as rid the smoker of paint odor that can impart unnatural
flavors to the first meal prepared. Cure your smoker periodically
throughout the year to protect against rust.

1. Remove water pan from smoker. Lightly coat all interior surfaces of

smoker and cooking grill with vegetable oil or vegetable oil spray. Do
not coat base pan, burner, lava rocks or lava rock grate.

2. Follow instructions carefully in this owner’s manual for proper lighting

procedures.

NOTE:

Always use propane tank valve to turn the smoker “ON” and
“OFF”. Use burner control knob to adjust flame only.

3. Close dome lid and allow temperature to reach the “Ideal” range on the

heat indicator. Maintain this temperature for two hours, then allow
smoker to cool completely. It is important that the exterior of the
smoker is not scraped or rubbed during the curing process.

IMPORTANT:

To protect your smoker from excessive rust, the unit must
be cured periodically and covered at all times when not in
use. A smoker cover may be ordered directly from
Brinkmann by calling 1-800-468-5252.

Curing Your Smoker

Lighting Instructions

CAUTION:

Before each use, check handles and support brackets to make
sure they are securely fastened.

1. Remove dome lid and smoker body from base pan.

2. Make sure the burner control knob on the control panel is in the “OFF”

position.

3. Open the propane tank valve two full turns.

4. Push in burner control knob and turn counter-clockwise to “Light”

position. Turn ignitor knob clock-wise several times. If burner does not
light within 5 seconds, turn propane tank valve and burner control
knob off immediately. Always wait at least 5 minutes for gas fumes to
dissipate prior to repeating this step.

Agvcd hvhj wdcjhw skb wckjnb
hbl lkb wdcj bchjkd olwudgvc
ufyvg. Vhg few luihi ubyg kuv
uhfuh cdndcu. Hosn bdyqe
dbduh xdhdsy zxjmqi cbvdft
sjkxn cbdstgw ajhal kjf ngfxyr htr
khtck kuyg wsfkhv wfuyg bsdjvc
dbd bcsusc mnscgjh scjhbn sdjh
vbsy ashgvasd. Vhg few luihi
ubyg kuv uhfuh cdndcu. Hosn
bdyqe dbduh xdhdsy zxjmqi
cbvdft sjkxn cbdstgw ajhal kjf
ngfxyr htr khtck kuyg wsfkhv.

Burner

Control Knob

Ignitor Knob

9

Advertising