Bendix Commercial Vehicle Systems PP-DC PARK CONTROL VALVE 6/07 User Manual
Page 6
6
5. Install o-ring(1) onto the guide spool. Then install the
guide spool over the plunger and into the body. Press
the guide spool into place fi rmly.
6. Place the cover onto the body and secure with its four
screws. Torque to 35 in. lbs.
7. Thread the button clockwise onto the plunger stem.
It should take approximately three (3) full button
revolutions to install it on the plunger. The protrusions
on the side of the plunger should line up with the button
grooves. Push on the button a number of times to make
sure the plunger moves freely throughout its range of
motion.
NOTE: BEFORE PLACING THE VEHICLE BACK
INTO SERVICE, PERFORM THE “LEAKAGE AND
OPERATIONAL TESTS” IN THIS DOCUMENT.
SD-03-3619_US_006 © 2013 Bendix Commercial Vehicle Systems LLC, a member of the Knorr-Bremse Group. All Rights Reserved.