Bendix Commercial Vehicle Systems E10P BRAKE VLV 3/04 - Manual

1
Bendix ® E-8P ™ & E-10P ™ Dual Brake Valves
DESCRIPTION
Refer to Figures 4, 5 and 6 for item numbers referenced
in parenthesis.
The Bendix ® E-8P ™ (Figure 1) and E-10P ™ (Figure 2)
dual brake valves are fl oor mounted, treadle operated
type brake valves with two separate supply and delivery
circuits for service (primary and secondary) braking, which
provides the driver with a graduated control for applying and
releasing the vehicle brakes.
The E-10P ™ dual brake valve (Figure 2) is similar to the
E-8P ™ dual brake valve except that a metal coil spring
(5) housed in an upper body assembly replaces the
rubber spring (27) used in the E-8P
™ valve. The use
of a metal coil spring (and the upper body assem-
bly) provides greater treadle travel and, therefore,
provides the driver with a less sensitive “feel” when
making a brake application. The E-10P
™ dual brake
valve is generally used on buses, where smooth brake
applications contribute to passenger comfort.
The circuits in the E-8P ™ /E-10P ™ dual brake valves are
identifi ed as follows: The No. 1 or primary circuit is that
portion of the valve between the spring seat which contacts
the plunger and the relay piston; the No. 2 or secondary
circuit is that portion between the relay piston and the
exhaust cavity.
The primary circuit of the valve is similar in operation to a
standard single circuit air brake valve and under normal
operating conditions the secondary circuit is similar in
operation to a relay valve.
Both primary and secondary circuits of the brake valve use
a common exhaust protected by an exhaust diaphragm.
FIGURE 1 - E-8P ™ DUAL BRAKE VALVE FIGURE 2 - E-10P ™ DUAL BRAKE VALVE
VALVE
MOUNTING
PLATE
TREADLE
SUPPLY
DELIVERY
(4)
AUXILIARY
SUPPLY
VALVE
MOUNTING
PLATE
TREADLE
DELIVERY
(4)
SUPPLY
(4)
EXHAUST
EXHAUST
SD-03-830