Bendix Commercial Vehicle Systems SMS-9700 ACCESSORY SOLENOID MANIFOL - Manual (Page 3)

3
REMOVAL
1. Prior to removing a solenoid, apply the parking brakes
and drain all the vehicle reservoirs. Refer to the General
Safety Guidelines in this manual before performing any
service.
2. Identify, mark, and disconnect all air lines to the
solenoid. Push-to-connect fi ttings require the collar
to be pressed toward the valve body before the nylon
line can be pulled. Note that the braided hose version
(Arctic) uses compression fi ttings.
LEAKAGE CHECKS
With the air system fully charged, coat the exhaust ports
of the solenoid with a soap solution. A 1-inch bubble in
three (3) seconds is permitted (175 SCCM).
If the solenoid does not function as described above, or if
leakage is excessive, it is recommended that it be replaced
with a genuine Bendix
® service replacement.
FIGURE 3 - SERVICING THE BENDIX ® SMS-9700 ™ SOLENOID MANIFOLD
END CAP
LOCKING TAB LOCKING TAB
O-RING - 2
BODY BOLT
NON-REMOVABLE
FASTENER
COMMON RAIL
SUPPLY PORT
SUPPLY END CAP CONFIGURATIONS -
THESE END CAPS ARE USED WHEN
A 3/8" NYLON AIR LINE IS USED TO
SUPPLY THE MANIFOLD
STRAIGHT -
3/8" PTC
90° ELBOW
3/8" PTC