Bendix Commercial Vehicle Systems GEN 5 ABS - Manual (Page 21)

21
Fault Codes
1 1 –/– No Trouble Found
2 1 001/000 Sensor air gap too large. Left Steer Sensor
2 2 001/008 Air gap too large or sensor shorted.
2 3 001/010 Speed Sensor signal is noisy.
2 4 001/008 Wheel locked too long during an ABS cycle.
2 5 001/008 High deceleration rate at wheel site or sensor shorted.
2 6 001/012 Sensor shorted low or high or sensor open.
2 7 001/012 Internal error at the sensor port of the ECU.
2 8 001/002 Sensor in the wrong location for the system configuration.
3 1 002/000 Sensor air gap too large. Right Steer Sensor
3 2 002/008 Air gap too large or sensor shorted.
3 3 002/010 Speed Sensor signal is noisy.
3 4 002/008 Wheel locked too long during an ABS cycle.
3 5 002/008 High deceleration rate at wheel site or sensor shorted.
3 6 002/012 Sensor shorted low or high or sensor open.
3 7 002/012 Internal error at the sensor port of the ECU.
3 8 002/002 Sensor in the wrong location for the system configuration.
4 1 003/000 Sensor air gap too large. Left Rear Sensor.
4 2 003/008 Air gap too large or sensor shorted.
4 3 003/010 Speed Sensor signal is noisy.
4 4 003/008 Wheel locked too long during an ABS cycle.
4 5 003/008 High deceleration rate at wheel site or sensor shorted.
4 6 003/012 Sensor shorted low or high or sensor open.
4 7 003/012 Internal error at the sensor port of the ECU.
4 8 003/002 Sensor in the wrong location for the system configuration.
5 1 004/000 Sensor air gap too large. Right Rear Sensor.
5 2 004/008 Air gap too large or sensor shorted.
5 3 004/010 Speed Sensor signal is noisy.
5 4 004/008 Wheel locked for too long during an ABS cycle.
5 5 004/008 High deceleration rate at a wheel site or sensor shorted.
5 6 004/012 Sensor shorted low or high or sensor open.
5 7 004/012 Internal error at the sensor port of the ECU.
5 8 004/002 Sensor in the wrong location for the system configuration.
Blink Codes
1st. 2nd.
Description
Location
MID 136
SID/FMI