Barco Coronis Fusion 10MP - Manual (Page 20)

20 Coronis Fusion 10MP
First time starting up
You are now ready to start up your C ORONIS F USION 10MP display system
for the first time.
1 Switch on your C
ORONIS
F
USION
10MP display as described in
“Stand-by switching” on page 24.
2 Turn on the computer connected to your display.
If you have properly installed your display and display controller, the
Windows start-up messages will appear once the boot procedure is
finished.
Your C ORONIS F USION 10MP display will be running in a basic
video mode at a default refresh rate when first time starting
up.
If you are using a Barco display controller, please consult the
user guide delivered with it to install the drivers, software and
documentation. When this is done, your display will
automatically detect the connected video input signal(s) and
apply the correct video mode and refresh rate.