Bird Technologies SK-4000-TC-Manual - Manual (Page 49)

37
Chapter 7 Maintenance
Cleaning
Clean the SiteHawk SK-4000 Analyzer only with a soft cloth dampened with mild
detergent and water. Do not use any other type of cleaning solution.
CAUTION
Do not touch the center pin with bare hands, water, or emery cloth.
Otherwise, damage may occur to the connectors surface.

Clean the connector using a cotton swab dipped into an isopropyl alco-
hol solution.

Before using connectors, to make sure that it is dry.

Before connected with the anode of coaxial connector calibrated the
wrench.
Charging the Battery
The internal battery pack will automatically recharge when the SiteHawk
Analyzer is plugged in.
CAUTION
Only use the supplied AC adapter to charge the unit.
The unit cannot be charged from a standard USB port (i.e. from a laptop).
Charging from a standard USB port could damage the power source.
Recharging time, from a full discharge, is approximately 5 hours.
Device Check
Instrument Calibration should only be performed by a certified service produc-
ers or authority.
It is recommended that an Instrument Calibration is done every three years.
Storage
Store the SiteHawk Analyzer in an enclosed case and in an environment that does not
exceed values listed in the Specifications section..
Ensure that the equipment stored away from dust, acidic and alkaline environ-
ment, explosive gas, and other causes of corrosion.