Bird Technologies SA-6000XT-Manual User Manual
Site analyzer™ xt
Advertising
SITE ANALYZER™ XT
CABLE AND ANTENNA TESTER
FOR WIRELESS SYSTEMS
OPERATING INSTRUCTIONS
©Copyright 2012 by Bird Electronic Corporation
Instruction Book Part Number 920-SA-XT Rev. P3
Site Analyzer is a trademark of Bird Electronic Corporation
Microsoft® and Windows® are registered trademarks
of the Microsoft Corporation
This is a preliminary manual. Specifications, limits, and text are subject to change
without notice. The information within this manual was as complete as possible
at the time of printing. Bird Electronic Corporation is not liable for errors.
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- SITE ANALYZER™ XT
- Chapter 1 Introduction
- Chapter 2 Calibration
- Chapter 3 Measure Match Mode
- Determine the Power of the Component Being Tested
- Selecting the Measure Match Mode
- Setting the Measurement Frequency
- Selecting the Measurement Units
- Setting the Measurement Scale Limits
- Setting the Measurement Data Points
- Setting the Graph Display Type
- Set and Activate Acceptance Limits
- Measure the Match of the Component
- Interpreting the Measurement
- Cable Loss Measurement
- Chapter 4 Fault Location Mode
- Determine the Power of the Component Being Tested
- Selecting Fault Location Mode
- Setting the Frequency Span and Max Distance
- Setting the Maximum Distance
- Setting the Cable Type
- Setting the Distance and Units
- Setting the Scale & Unit of Measure
- Set the Measurement Data Points
- Set the Graph Display Type
- Set and Activate Acceptance Limits
- Test for Fault Location
- Interpreting the Fault Location Measurement
- Chapter 5 Power Measure Mode
- Chapter 6 General Operation
- Chapter 7 Utilities
- Chapter 8 Computer Software
- Chapter 9 Maintenance