Bird Technologies 5000-XT-Quick Start - Manual

920-5000-XT-QSG Rev A www.bird-electronic.com (866) 695-4569
5000XT DPM Quick Start Guide
Installing the Battery
1. Lay the DPM, display side down, on a clean surface.
2. Remove the two mounting screws from the back cover.
3. Remove the back cover.
4. Install the battery.
5. Replace the back cover.
6. Secure the back cover with the mounting screws.
7. Attach the DPM to an external power source to charge the battery.
8. Charge the battery for five hours before use.
Connecting
Note: If the 5000-XT is connected to a PC when starting or restarting the
PC, it may cause the boot process to lock up. Disconnect the 5000-XT before
starting or restarting the PC.
Note: Use the appropriate Bird Power sensor for the RF power measurement
application. An attenuator may be required.
WARNING
Do not connect to any external power before disassembly.
The potential for electric shock exists.
WARNING
Never attempt to connect or disconnect RF equipment from the transmission line
while RF power is being applied.
Leaking RF energy is a potential health hazard.
RF voltage may be present in RF element socket.
Keep element in socket during operation.
Back Cover
Mounting
Screws
Battery