Charging flat track, Turning flat track on, Turning flat track off – Blackline GPS Flat Track User Manual
Page 12
10 // USER GUIDE
Charging Flat Track
1. Plug the wall charger into an electrical outlet (some outlets are controlled by a
wall switch).
2. Insert the Micro USB Cable Plug into the corresponding Micro USB Charging
Jack on the charging clip ensuring the USB symbol
on the cable faces the
flat side of the charging clip
3. Slide the charging clip onto Flat Track ensuring the electrical contacts on the clip
connect with the contacts on the back of Flat Track and the alignment button
snaps into place on the front.
4. Completely charge Flat Track for 16 hours.
5. Remove the charging clip from Flat Track.
Charging status can be determined by observing the Green Battery/Charging Lights.
See the section Green Battery/Charging Lights for more detailed information.
If Flat Track is in a very low power state, it may take up to an hour of charging before
the charging state can be observed.
Turning Flat Track On
1. Press either of the two Power/Status buttons for one second to turn Flat Track on.
2. Flat Track will attempt to connect to a wireless network.
Flat Track needs to have sufficient battery power to connect to the wireless network.
It takes approximately one minute for Flat Track to connect to the wireless network.
Turning Flat Track Off
1. Press either of the Power/Status buttons once to wake up the Green Status Light
Stealth Mode.
2. Simultaneously press the two Power/Status buttons for two seconds to power
Flat Track off.
Flat Track will flash all of the Green Status Lights and Green Battery/Charging Lights
while turning off during the shutdown sequence.
When Flat Track is off, you are not able to remotely turn the device on. You must
physically turn it back on when you wish to use it further.