Blizzard Lighting 5 Flurry - Manual (Page 11)

Page 11
Flurry™ 5 User Manual Rev. A (c) 2013 Blizzard Lighting, LLC
Control Panel Menu Structure
**HOLD The <MENU> Button for 5 seconds to confirm any function. **
Display Selection Function
Addr A001 - A512
Sets the fixture DMX Address & Sets
the fixture to DMX Mode.
ChNd 8Ch -13Ch
Sets the fixture in 8 (Basic) or 13 (Ex-
tended) DMX channel mode.
SLNd NAST - SL 1 - SL 2
Sets the fixture’s profile as Master
(NAST), Slave Mode 1 (SL 1), or Slave
Mode 2 (SL 2).
SouN 0 - 100
Sets the fixture in Sound Active mode,
and sets the sound sensitivity of the
unit’s internal microphone.
AuTo No - YES Sets the fixture in Auto Run mode.
STbY No - YES
Sets the unit to enter “Standby Mode”
when not receiving DMX signal, other-
wise the unit will automatically enter
Master/Slave Mode.
PAN No - YES
Sets the pan function to normal (NO) or
inverse (YES).
TILT No - YES
Sets the tilt function to normal (NO) or
inverse (YES).
dISP dSIP Sets the display to normal or inverted.
TEST <ENTER> Sets the fixture in internal test mode.
hour <ENTER>
Displays the fixture’s total running
hours.
rSET <ENTER> Resets the fixture.
BALA
rEd - GrEE - bLuE -
Anbr - UhIT
Adjusts the color balance of each color
between 0 (lowest) and 255 (highest)
NOTE: Color balance adjustment is accessed by holding the <ENTER> button
for 5 seconds while in any operating mode.