Blizzard Lighting TOURnado IP Beam - Manual (Page 3)

Page 3
TOURnado™ IP Beam User Manual Rev. A © Copyright 2014 Blizzard Lighting, LLC
1. GETTING STARTED
What’s In The Box?
• 1 x TOURnado™ IP Beam Professional LED PAR Fixture
• 1 x IP Rated AC power cord with cable cap
• 1 x Set of IP Rated DMX in/out cables
• This Lovely User Manual
Optional Accessories (sold separately)
The following accessories are available for this fixture. But the lone wolves that they are, they must be
purchased separately. Contact your authorized Blizzard Lighting dealer for pricing!
• CABLE_TOURData1M: 1-Meter IP-Rated DMX Extension Cable
• CABLE_TOURPower1M: 1-Meter IP-Rated Power Extension Cable
• CABLE_TOURData3M: 3-Meter IP-Rated DMX Extension Cable
• CABLE_TOURPower3M: 3-Meter IP-Rated Power Extension Cable
• CABLE_TOURData5M: 5-Meter IP-Rated DMX Extension Cable
• CABLE_TOURPower5M: 5-Meter IP-Rated Power Extension Cable
Getting It Out Of The Box
Congratulations! You’re now the proud owner of one tough, slightly pumpkin shaped PAR fixture! And now
that you’ve got your TOURnado™ (or hopefully, TOURnados!), you should carefully unpack the box and
check the contents to ensure that all parts are present and in good condition. If anything looks as if it has
been damaged in transit, notify the shipper immediately and keep the packing material for inspection.
Again, please save the carton and all packing materials. If a fixture must be returned to the factory, it is
important that the fixture be returned in the original factory box and packing.
Powering Up!
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to
100% switch.
AC Voltage Switch - Not all fixtures have a voltage select switch, so please verify that the fixture you
receive is suitable for your local power supply. See the label on the fixture or refer to the fixture’s
specifications chart for more information. A fixture’s listed current rating is its average current draw under
normal conditions. Check the fixture or device carefully to make sure that if a voltage selection switch
exists that it is set to the correct line voltage you will use.
Warning! Verify that the voltage select switch on your unit matches the line voltage applied.
Damage to your fixture may result if the line voltage applied does not match the voltage
indicated on the voltage selector switch. All fixtures must be connected to circuits with a
suitable Ground (Earthing).
Getting A Hold Of Us
If something is wrong, just give us a call or send an email. We’ll be happy to help, honest.
Blizzard Lighting
N16 W23390 Stoneridge Dr. Ste E
Waukesha, WI 53188 USA
www.blizzardlighting.com
414-395-8365
Email: [email protected]
Disclaimer: The information and specifications contained in this document are subject to change without
notice. Blizzard Lighting™ assumes no responsibility or liability for any errors or omissions that may
appear in this user manual. Blizzard Lighting™ reserves the right to update the existing document or
to create a new document to correct any errors or omissions at any time. You can download the latest
version of this document from www.blizzardlighting.com.
Author: Date: Last Edited: Date:
J. Thomas 5/26/2014 J. Thomas 5/28/2014