Blizzard Lighting TOURnado IP EXA - Manual (Page 12)

Page 12
TOURnado™ IP EXA User Manual Rev. A © Copyright 2014 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address:
The default mode for the fixture is DMX, so the first menu item that you can edit is the
starting DMX address.
1.) Navigate the menu using the <UP/DOWN> buttons until you reach Addr.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select a DMX channel from 001-512.
4.) Press the <ENTER> button to confirm.
Select the DMX Channel Mode:
1.) Navigate the menu using the <UP/DOWN> buttons until you reach CHnd.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select either 6CH, 9CH, or 11CH mode.
4.) Press the <ENTER> button to confirm.
Slave Mode:
To synchronize one or more fixtures to follow the actions of the Master fixture (the 1st unit in
the DMX chain), perform the following steps on each Slave fixture:
1.) Set the DMX address to A001.
2.) Navigate the menu using the <UP/DOWN> button until you reach SLAU.
3.) Push the <ENTER> button.
4.) Use the <UP/DOWN> buttons to select SLAu.
5.) Press the <ENTER> button to confirm.
Auto, Stand-Alone, & Built-in Program Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
Auto Mode:
1.) Navigate the menu using the <UP/DOWN> button until you reach ASC-.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select from AC00-AC15.
4.) Press the <ENTER> button to confirm.
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) Navigate the menu using the <UP/DOWN> button until you reach Pr--.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select from Pr00-Pr63.
4.) Press the <ENTER> button to confirm.
Flash/Fade Modes:
1.) Navigate the menu using the <UP/DOWN> buttons until you reach FLAS or FAdE.
2.) Push the <ENTER> button.
3.) Now, you can adjust the flash rate from FL00-FL15 or the fade speed from FA00-FA15
with the <UP/DOWN> buttons. Press the <ENTER> button to confirm.
Built-in Program Speed:
1.) Navigate the menu using the <UP/DOWN> button until you reach SP-.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select from SP00-SP15.
4.) Press the <ENTER> button to confirm.
Manual Color Adjustment:
1.) Navigate the menu using the <UP/DOWN> button until you reach either rL-- (Red),
GL-- (Green), bL-- (Blue). AL-- (Amber), UL-- (White), or uL-- (UV) then hit <ENTER>.
2.) Using the <UP/DOWN> buttons, select the maximum level for each color between
x000-x255 (000=off), then hit <ENTER> to confirm.