Blizzard Lighting KONTROL 5 Skywire DMX Controller - Manual (Page 9)

Page 9
KONTROL 5 Skywire Manual Rev. A Copyright © 2013 Blizzard Lighting, LLC
3.1.4 Resetting The System
WARNING: This will reset the controller to its factory defaults. ALL PRO-
GRAMS AND SETTINGS WILL BE ERASED!
1. Turn the unit off.
2. Press and hold <EDIT/REC>, <RUN MODE> & <DEL/CLEAR>
3. Turn the unit on while you continue to hold <EDIT/REC>,<RUN
MODE> & <DEL/CLEAR>
4. The display will read
rESr
, then
ot
, then
u2.0
, then
D000
. At that
point, release all 3 buttons.
5. The settings will be reset to factory defaults.
3.2 Programming
Regardless of whether you are programming a chase or scene, you must first
enter programming mode.
3.2.1 Entering Programming Mode
1. Press and hold <EDIT/REC> for 3 seconds.
2. The Program/REC LED indicator will blink, indicating programming is
active.
3. The LED indicators for any previously programmed scenes in the cur-
rent bank and any previously programmed chases will blink.
4. Programming mode is now active.
3.3 Color/Scene Preset Programming Mode
This allows the user to create a preset color/scene which can be used to
override current fixture output and may also be used in chase programming.
3.3.1 Creating A New Color/Scene Preset
1. Enter programming mode as described in Section 3.2.1.
2. Using the <FIXTURE SELECTOR> button(s), select the fixtures to
include in the Color/Scene Preset.
3. Adjust the fixture(s) output using <CHANNEL FADERS 1-5> as
desired.
4. Press <EDIT/REC>.
5. Select the desired scene page using <SCENE PAGE>.
6. Press <SCENE 1-8>. All LEDs will flash quickly.
7. Repeat steps 1-6 to add additional presets if desired.
8. Hold <EDIT/REC> for 3 seconds to exit programming mode. The
LED indicator above the <EDIT/REC> button will extinguish.
3.3.2 Color/Scene Preset Delete Mode
This allows the user to delete a previously programmed preset color/scene.
1. Enter programming mode as described in Section 3.2.1.
2. Select the desired scene bank using <LEFT/RIGHT>.
3. Hold <DEL/CLEAR>, then press the <SCENE 1-8> button you wish
to delete.