Blomberg TKF 7231 User Manual

Page 49

Advertising
background image

49 EN

turning the programme selection knob. Only

the drying light turns on and the machine

remains in hold until a new programme is

selected and the “Start/Pause/Cancel” button

is pressed. Child-proof lock of the machine

should not be active in order to perform

these two operations. If the child-proof lock is

active, deactivate it before performing these

operations.

Adding/removing laundry in standby mode

In order to add or remove laundry after the

programme starts:

1. Press the “Start/Pause/Cancel” button to

switch the dryer to “Pause” mode. Drying

process will stop.

2. Open the door at “Pause” position and

close it again after adding or taking out

laundry.

3. Press “Start/Pause/Cancel” button to start

the programme.

C

Any laundry added after the drying process

has started may cause the dried clothes in

the machine intermingle with wet clothes

and the result will be wet laundry after the

drying process is over.

C

Laundry may be added or taken out

as much as desired during a drying

process, but this process will extend the

programme duration and increase energy

consumption since the drying will be

interrupted continuously. Therefore, it is

recommended to add laundry before the

drying programme has started.

Child-proof lock

There is a child-proof lock to prevent any

programme interruption due to the pressing

of button while the programme is running.

The loading door and all buttons except the

“On/Off” button on the control panel are

deactivated when the child-proof lock is active.

Press the “Start/Pause/Cancel” and “Cancel

audio warning” buttons simultaneously for 3

seconds to activate the child-press lock.

To start a new programme after the

programme is over or to interrupt the

programme, the child-proof lock should be

deactivated. Press the same buttons for 3 sec.

again to deactivate the child-proof lock.

C

Child-proof lock is deactivated when the

machine is restarted by pressing the On/Off

button.

C

Press the relevant buttons for 3 seconds to

activate the child-proof lock. A long beep

will be heard and the child-proof lock will

be activated. A double beep will be heard if

you press any button or turn the programme

selection knob while the child-proof lock is

active. Press the buttons for 3 seconds to

deactivate the child-proof lock. Single beep

will be heard and child-proof lock will be

deactivated.

A

A double beep will be heard if you turn

the programme selection knob when the

machine is running and the child-proof lock

is active. If you deactivate the child-proof

lock without returning the program selection

knob to its previous position, the programme

will be terminated since the position of the

programme selection knob is changed. The

drying light turns on and the machine remains

on hold until a new programme is selected

and the “Start/Pause/Cancel” button is

pressed.

Finishing by canceling the programme

To cancel any selected programme:

Press “Start/Pause/Cancel” button for about

3 seconds. The “Filter cleaning”, “Water tank”

and “End/ Anti-creasing” warning lights will

turn on at the end of this period for reminding

purposes.

A

As the inside of the dryer will be excessively

hot when you cancel the programme while

the dryer is running, activate the ventilation

programme to cool it down.

End of programme

The “End/Anti-creasing”, “Filter cleaning” and

“Water tank” warning lights on the programme

follow up indicator will turn on when the

programme comes to an end. The door can be

opened and the machine becomes ready for a

second cycle.

Press “On/Off” button to turn off the dryer.

C

Final step of the drying cycle (cooling step) is

performed without heat application in order to

keep the items at a temperature that would

not harm them.

C

A 2-hour anti creasing programme to prevent

laundry from creasing will be activated if

you do not take the laundry out after the

programme has come to an end.

C

If you will not take the laundry out immediately,

do not stop the dryer before the drying

process is complete.

C

Clean the filter after each drying (please see,

Filter cleaning).

C

Drain the water tank after each drying (please

see, Water tank)

Advertising