Boundless Technologies Ethernet Interface Adapter - Manual (Page 13)

Connect to Host 9
Comm Protocol
The adapter’s communication protocol could be set to None,
Xon/Xoff, DTR/DSR, or Both. This setting should match the
terminal’s communication protocol setting for the EIA port or
else the terminal could lose data. If the communication
protocol is set to None, the terminal could lose data.
Recall Saved Setting
Selecting option number 7 from the Setup Menu sets the values
of options 1 through 5 to that currently stored in NVRAM.
Message Recall complete indicates a successful recall.
Save Settings for Powerup
When all of the terminal’s Ethernet settings are acceptable,
select option number 8 from the Setup Menu to save the
displayed values in NVRAM.
Exit Setup Menu
When satisfied with all of the terminal’s Ethernet settings,
press 9 to return to the Main Menu.
- MAIN MENU -
Status > Disconnected from Host
Host IP Address > XXX.XXX.XXX.XXX
1. Setup Menu
2. Connect to Host
3. Ping
4. Hardware Information
--------------------------
9. Exit Main Menu
Connect to Host
Once all the necessary addresses have been established, the
terminal is ready to initiate a Telnet connection to the selected