Blomberg MEE 1030 X - Manual (Page 5)

EN 5
2 Radio Interference
3 Installation
IMPORTANT
The wires in this mains lead are
coloured in accordance with the
following code:
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wires in the mains
leads of the appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured green-and-
yellow must be connected to the terminal
in the plug which is marked with the letter
E or by the earth symbol coloured
green of green-and-yellow.
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
Microwave oven may cause interference
to your radio, TV, or similar equipment.
When interference occurs, it may be
eliminated or reduced by the following
procedures. a. Clean the door and sealing surface
of the oven.
b. Place the radio, TV, etc. as far
away from your microwave oven as
possible.
c. Use a properly installed antenna for
your radio, TV, etc. to get a strong
signal reception.
1. Make sure all the packing materials
are removed from the inside of the
door.
2. Inspect the oven after unpacking for
any visual damage such as:
- Misaligned Door
- Damaged Door
- Dents or Holes in Door Window
and Screen
- Dents in Cavity
- If any of the above are visible, DO
NOT use the oven.
3. This Microwave Oven weighs
13.5 kg and must be placed on a
horizontal surface strong enough to
support this weight.
4. The oven must be placed away from
high temperature and steam.
5. DO NOT place anything on top of
the oven.
6. Keep the oven at least 8 cm away
from both sidewalls and 10 cm
away from rear wall to ensure the
correct ventilation.
7. DO NOT remove the turn -table
drive shaft.
8. As with any appliance, close
supervision is necessary when used
by children.
WARNING - THIS APPLIANCE MUST
BE EARTHED.
1. The plug socket should be within
easy reach of the power cord
2. This oven requires 1.5 KVA for
its input consultation with service
engineer is suggested when
installing the oven.
CAUTION: This oven is protected
internally by a 250V,10 Amp Fuse.