BLUESHAPE CVS4X User Manual
Page 10
10
Please note that:
-
If the battery is installed on the same side of the battery on
charge, it will only start charging when the first one has finished
charging.
- If the battery is installed on the opposite side, it will start
charging immediately and independently.
The LEDs will always display the correct status of the charging
process for each battery.
In the case when an accessory is plugged into the accessories XLR,
the charging process will be suspended. The AUX LED will light up
and the other battery LEDs will show 'WAITING'. Once the
accessory has been unplugged, the charger will continue the
previous charging sequence, from the original point of interruption.
PLEASE NOTE THAT THE MAXIMUM LOAD THAT CAN BE
CONNECTED TO THE XLR OUTPUT MUST NOT EXCEED 110W.
ADDITIONAL SAFETY NOTES
Chargers and/or batteries may become hot during
charging. This is normal. Please consult your
BLUESHAPE dealer if you notice that either a
charger or a battery, become excessively hot during
the charging operation.
Be careful not to block the equipment’s ventilation
outlets.
Never insert any metallic or any other objects inside
the equipment through the ventilation openings or
otherwise.
CVS4X
BV070
BV100
BV140
BV175
BV210
1) Push and hold the
button in the direction
of the arrow
2) Pull out the battery in
the direction of arrow