BLUESHAPE CVTR2 User Manual
Page 9
9
Operating Instructions - CVTR2
This charger sequentially charges two batteries with charging
currents of up to 4 Amperes.
How to proceed:
-
Pull out and rotate the aluminium foot 90° in a left or right hand
direction for vertical freestanding operation. The unit has been
designed to remain in balance with only one battery or with both
batteries connected, if this set-up is respected.
-
Plug the AC power cord provided into the charger AC input
-
Plug and switch on the AC mains supply
-
Insert a battery inside any one of the two V-plate adapters as
shown (see picture)
-
Observe the LED. In addition, the charge status may be read in
20% steps through the BLUESHAPE battery LED array.
-
Leave the battery to charge for the appropriate time (see table
on page 6)
-
Remove the battery when the LED becomes steady green as
shown (see picture on next page)
In the case when you want to charge 2 batteries: insert the second
battery into the second V-plate adapter. This second battery will
start charging when the first battery has finished charging.
CVTR2
BV070
BV100
BV140
BV175
BV210
Insert in the direction of the arrow