Brandmotion 1008-9527-V1 - Manual (Page 12)

INSTALLATION INSTRUCTIONS
9527 Ford Flex Instructions 7-27-12.doc 12 of 18
Section 6C: Compass Wiring for Vehicles with 10-pin Mirror Connector
53. On the supplied interior harness, near the black
16 pin connector, locate the seven loose wires.
Isolate and tape over the loose orange and white
wires as they will not be used. Using Connector C925
pinout diagram opposite, splice the remaining six
wires to the vehicle mirror harness wires where the
mirror connector was removed in Section 4
as
follows:
• Splice the supplied interior harness black
ground wire to the loose vehicle mirror
ground wire that was in pin 10.
• Splice the supplied interior harness green
reverse wire to the loose vehicle mirror
reverse wire that was in pin 3.
• Splice the supplied interior harness pink
ignition wire to the loose vehicle mirror
ignition wire that was in pin 1.
• Splice the supplied interior harness red
compass (+) to the loose vehicle mirror
compass (+) wire that was in pin 6.
• If populated, splice the supplied interior
harness yellow compass (-) to the loose
vehicle mirror compass (-) wire that was in
pin 2.
54. If you removed the compass circuit board,
per section 6A, on the supplied interior harness,
near the black 6 pin connector, locate the five short
wires. Using Connector C925 pinout diagram opposite,
splice the remaining four wires to the vehicle mirror
harness connector removed in Section 4 as follows:
• Splice the supplied interior harness black
ground wire to the vehicle mirror connector
ground wire. (pin 10).
• Splice the supplied interior harness green
reverse wire to the vehicle mirror connector
reverse wire. (pin 3).
• Splice the supplied interior harness pink
ignition wire to the vehicle mirror connector
ignition wire. (pin 1)
• Splice the supplied interior harness yellow
compass (-) wire to the vehicle mirror
connector compass (-) wire. (pin 2).
• Splice the supplied interior harness red
compass (+) wire to the vehicle mirror
connector compass (+) wire. (pin 6).
• If you did not remove the compass circuit
board, isolate the five loose wires with
electrical tape, as they will not be used.
NOTE: If reverse signal does not exist in Pin 3 of 10-
pin mirror C925 connector (see diagram below),
then follow directions in Section 8 to connect
reverse.
Supplied Interior
Harness Color
Pink (12V + Ignition
Yellow (-)
Green
Red (+)
Black
C925
Supplied Interior
Harness Color
Pink (12V + Ignition
Yellow (-)
Green
Red (+)
Black
Supplied Interior
Harness Color
Pink (12V + Ignition
Yellow (-)
Green
Red (+)
Black
NOTE: Circuit colors shown may
vary depending on model and
year. Verify pin locations and
check circuit for proper function
using a digital volt-ohm meter.