Brandmotion 1008-9525-V2 - Manual

INSTALLATION INSTRUCTIONS
9520 and 9525 Instructions 9-24-12.doc 1 of 34
Rear Vision System – Tailgate Handle Camera Mirror Display
2004-Current Ford F-150 and 2008-Current Ford Super Duty
(Kit part numbers 1008-9520 and 9525)
Kit Contents: Tools Required:
Mirror
Tailgate Handle with camera and harness
Interior (shorter) Harness
Chassis (longer) Harness
2 Foam pieces (if needed and optional)
1 bag containing:
25 Wire Ties (short)
7 pairs of T-taps (optional)
(Splice, solder & heat shrink
recommended.)
Z-Tech (in a white bottle)
1 bag containing:
2 Templates (along with these instructions)
2 Wire Ties (long and optional)
T20 and T30 Torx Drivers
8mm and 10mm Sockets
Flat Blade Screwdriver
Phillips Screwdriver
Plastic Trim Removal tool
Drill Bit
1 inch Center Hole Saw
Soldering Iron
Small brush
Round file (if needed)
Mirror removal tool # OTC8200
(Required for non-screw type mirrors)
Deburring Tool
Electrical Tape or Heat Shrink
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full
color instructions, as well as an installation video, please visit www.brandmotion.com
Preparation
• Ensure all lamps and accessories are OFF.
• Ensure the ignition switch is in the OFF position.
• Loosen the negative battery cable bolt. Remove negative battery cable from terminal and position away
from battery.
• Wait one (1) minute prior to working on the vehicle to assure airbag system has been disabled for your
safety.
PRE-INSTALLATION VEHICLE CHECKLIST
Before beginning, determine how the vehicle is equipped and check appropriate boxes:
Start vehicle and note location of compass display. Unplug mirror connector from back of mirror.
• If compass display on the dash shows (- -) the compass module must be relocated (refer to Section 6).
Determine whether the vehicle has an opening in the center of pickup bed close to opposite of the opening in
the bottom of the tailgate.
□ Yes, skip Section 1.
□ No, tailgate must be removed to drill an opening for the camera harness
(refer to Section 1).
□ Vehicle does NOT have an auto dimming inside mirror (refer to Section 7).
Determine the connector style used on the existing inside rearview mirror:
7-pin or 16-pin. For past models additional information, please see Section 10B (reference).
□ Check kit contents are complete against the list above.