Brandmotion 1009-9518 - Manual

INSTALLATION
INSTRUCTIONS
9518 Instructions 6-26-13.Doc Page 1 of 7
Rear Vision System – Mirror Display
2013-Current Ram (Kit part number 1009-9518)
Please read thoroughly before starting installation
and check that kit contents are complete.
Items Included in the Kit:
Rear Vision Display Mirror
Mirror Harness
Chassis Harness
Tailgate Handle with Camera
1 bag containing:
17 Wire Ties
Z-tec Corrosion Inhibitor
(in a white bottle)
1 bag containing:
These instructions
Template
1 bag containing:
Relay set (male & female connectors)
Tools Required:
Socket Wrench with 8mm & 10mm Sockets
T20 & T30 Torx Bits
Flat Blade Screwdriver
Power Drill
1/8” Drill Bit
1” Hole Cutter
Center Punch
Pushpin Removal Tool
Plastic Trim Removal Tool
Round File or Deburring Tool
Wire Stripper
Soldering Iron & Solder
Masking Tape
We strive to provide accurate and up-to-date installation instructions.
For the latest full color instructions, please visit www.brandmotion.com
Install Tailgate Handle Camera
1. Set up a work area on which to set the tailgate after
removal. This area should be well protected to avoid
damage to tailgate.
2. Use your fingers to remove the black plastic filler
panel at rear of pickup bed adjacent to the license
plate. Press on the end tab and lift outward. Next,
slide the red tab from the locked position and
unplug the tailgate power lock harness connector.
3. Unhook both tailgate support straps by inserting a
Flat Blade Screwdriver between the locking tab and
strap mount. Lift the locking tab away from the
strap mount with the screwdriver while sliding the
tailgate strap upwards. The tailgate strap hanger
can now be removed from the mount.
4. Open tailgate about ten degrees and lift right side of
the tailgate off the pin. Next, slide tailgate to the
right to remove taking care not to damage the paint.
NOTE: Tailgate removal and installation requires two
people.
NOTE 2: If your vehicle is equipped with a uConnect mirror, an aftermarket Microphone
(available separately as Brandmotion kit 5000-PESMVR) must be installed to maintain voice operation.
NOTE 1: The mirror in this kit has no provision for 911 or concierge button functions and is not
compatible with Exterior Auto Dimming Mirrors or Auto High Beam Control. Installation will result in
the loss of these functions.