Brandmotion 9002-9515 Installation Instructions - Manual

9515 only instructions 9-6-12 (1).doc Tel 734-619-1250
1 of 2 Toll Free 877-276-6456
Fax 480-247-5999
9002-9515 Installation Instructions (Auto Dimming Video Display Mirror)
IMPORTANT
: Read before installing. For the latest full color instructions please visit
www.brandmotion.com
Mirror Mounting - This mirror has a Wedge/ D-tab style mounting base. Please check our application guide to
ensure sure it is compatible with your vehcile (adapters are available for specific applications separately). Slide
the mirror onto the tab. Torque for the mirror screw that attaches to the windshield tab is 1.8 Nm (16 lb-in) and
cannot exceed 2.2 Nm (19.5 lb-in).
Camera requirements - The camera signal must be strong enough for the mirror to detect signal when reverse is
engaged. We recommend that the camera be connected to mirror prior to installation to confirm compatiblity. Best
results are on cameras that have a .8- 1.6 VDC coming out of video composite lead (commonly a yellow RCA
jack). Depending on camera output it may require reverse to be supplied by a 12V switched ignition rather than
reverse feed. To test this use a multimeter set to DC and connect the (-) lead to the camera RCA shield and the
(+) lead to the camera RCA tip with the camera powered ON.
Powering up the camera - The mirror stays ON for over 1 second when reverse is disengaged and if the camera
is connected to the reverse tail lamp then the screen will flash Blue. If the camera does not power up instantly
when the vehicle is shifted into reverse the screen will not detect the camera and will not display an image. For
these reasons we recommend that the camera be connected to Ignition (+).
!
!"##$%&"'()*%$(*#+(,*%-(")(./''"'(
/.*0$1(
!
White dot
identifies
cavity 1