Brandmotion 9002-9608 - Manual

9608 Instructions 11-12-12.doc Page 1 of 2
9002-9608 Installation Instructions (Slimline Auto Dimming
Wedge Mount Video Display Mirror)
IMPORTANT : Check kit contents and read instructions before installing. For the latest full color instructions please visit
www.brandmotion.com
Kit Contents: Slimline Auto Dimming Mirror with 3.5” Video Display and attached mirror harness
These Instructions
Mirror Removal & Mounting
NOTE: This mirror has a Wedge/ D-tab style mounting base. Please check our application guide to ensure it is compatible with your vehicle
(for specific applications, adapters are available separately). In some cases, it may be necessary to remove a cover to access the wedge
mount on the windshield and/or modify the cover slightly to clear the mirror mount.
To install:
1. Loosen vehicle mirror screw using a T20 Torx driver and
remove existing vehicle mirror. CAUTION: Do not twist
mirror as windshield damage could result.
2. Carefully slide supplied Mirror onto the windshield tab.
3. Torque supplied Mirror screw to 1.8 Nm (16 lb-in) and do
not
exceed 2.2 Nm (19.5 lb-in).
Mirror Wiring
1. Use a multimeter to test for vehicle Igniton (+) and
Reverse (+) signals. Typical locations are behind the
driver or passenger side kick panel or under the dash. Set
parking brake, start vehicle, and have an assistant shift
into Reverse while you test for Ignition & Reverse signals.
2. Route Mirror Harness beneath headliner
and down the A-pillar closest to the
Ignition and Reverse signal locations.
3. Splice Mirror Harness wires to the
following required connections:
Red - Ignition controlled power 12v+
when key is ON
Green - Connect to Reverse (+) power
(backup lamps)
Black - Chassis ground. A ground bolt is
commonly found in the front kick
panel area with other wires
attached; in some cases you may
need to supply a new screw.
4. Connect female RCA plug on supplied
Mirror Harness to male camera RCA.
Camera Requirements
The camera signal must be strong enough for the mirror to detect signal when reverse is engaged.
We recommend that the camera be connected to mirror prior to installation to confirm compatiblity.
Best results are on cameras that have a 0.8- 1.6v DC coming out of video composite lead (commonly a
yellow RCA jack). Depending on camera output it may require reverse to be supplied by a 12v switched
ignition rather than reverse feed. To test this use a multimeter set to DC and connect the (-) lead to
the camera RCA shield and the (+) lead to the camera RCA tip with the camera powered ON.
Mirror & Mirror Harness Pinouts
MIRROR
HARNESS
WIRE
COLOR
MIRRO
R
WIRE
COLOR
FUNCTION
White
Pin 1
Purple
Pin 1
Video (+)
Connects to RCA
Brown
Pin 2
White
Pin 2
Video (–)
Connects to RCA
Red
Pin 6
Red/Blue
Pin 6
Ignition Controlled
12v (+)
Green
Pin 7
Orange
Pin 7
Reverse (+)
(backup lamps)
Black
Pin 8
Black
Pin 8
Ground