Brandmotion 1110-2518 - Manual

2518 Instructions 12-5-13.doc Page 1 of 2
1110-2518 Installation Instructions (Auto Dimming Wedge Mount
Compass Mirror)
IMPORTANT : Check kit contents and read instructions before installing. For the latest full color instructions please visit
www.brandmotion.com
Kit Contents
Auto Dimming Mirror
Mirror Harness
Mirror Mounting
NOTE 1: This mirror has a Wedge/ D-tab style mounting base; please check our Application Guide to ensure it is compatible with your
vehicle. Additionally, Brandmotion offers windshield mirror adapter brackets which are available separately.
NOTE 2: In some cases, it may be necessary to remove the cover on the supplied mirror to access the wedge mount on the
windshield and/or modify the cover slightly to clear the mirror mount. Additionally, if your vehicle is equipped with a mirror cover,
mirror adjustability may be restricted.
To install:
1. Loosen vehicle mirror screw using a T10 Torx driver and remove
existing vehicle mirror.
CAUTION: Do not twist mirror as windshield damage could result.
2. Carefully slide supplied Mirror onto windshield tab.
3. Torque supplied Mirror screw to 1.8 Nm (16 lb-in) and do not exceed
2.2 Nm (19.5 lb-in).
Mirror Wiring
1. Use a multimeter to test for vehicle Igniton (+) and Reverse (+)
signals. Typical locations are behind the driver or passenger side kick
panel or under the dash. Set parking brake, start vehicle, and have
an assistant shift into Reverse while you test for Ignition and
Reverse signals.
2. Plug supplied Mirror Harness into supplied Mirror and
route beneath headliner and down the A-pillar closest
to the Ignition and Reverse signal locations.
3. Splice Mirror Harness wires to the following required
connections:
Red - Ignition controlled power 12v+ when key is
ON
Black - Chassis ground
Green - Connect to Reverse (+) 12V power.
NOTE: While not a required connection, connecting Reverse
disables the vehicle’s auto dim function while vehicle is in reverse.
4. If vehicle is equipped with Exterior Auto Dimming
Mirrors, use a multimeter to identify the appropriate
vehicle wires and splice the Blue wire to Exterior
EC (auto dimming) mirrors (–) and the White wire
to Exterior EC (auto dimming) mirrors (+)
IMPORTANT: If vehicle is NOT equipped with Exterior Auto
Dimming Mirrors, isolate Blue & White wires and cover
with electrical tape.
Mirror & Mirror Harness Pinout
PIN
MIRROR
WIRE
COLOR
MIRROR
HARNESS
WIRE COLOR
FUNCTION
1 - 3 N/A N/A Not used
4 Purple White*
Exterior EC
(auto dimming)
mirror (+)*
5 N/A N/A Not used
6 Red Red Ignition (+)
7 Orange Green Reverse (+)
8 Black Black Ground
9 Gray Blue*
Exterior EC
(auto dimming)
mirror (–)*
10 N/A N/A Not used
*If vehicle is equipped. Outside EC (auto dimming)
Drive is 1.20 - 1.30v DC.
These instructions only pertain to functions on the supplied
mirror and do not support other vehicle features.