Brandmotion 9002-7605 - Manual (Page 3)

2010-Current Ford Transit Connect Aftermarket CMOS Camera with Optional Parking
Gridlines Installation Instructions (Kit # 9002-7605)
7605 Ford Transit Connect Instructions 10-11-12.doc Page 3 of 3
Step 11: Secure Camera Harness and Chassis
Harness to existing vehicle wiring. Avoid binding or
otherwise damaging the harness (Recommended: Wire
Ties or Electrical Tape.)
Step 12: Connect Chassis Harness to supplied
Power Harness.
Step 13: Install aftermarket display/ Navigation
display as per instructions (if required).
Step 14: Connect the male RCA from the Power
Harness to the “Camera IN” on the aftermarket
display/ Navigation display.
Note: Connection to female RCA connector shown.
Step 15: Test the system. Inspect that all connections
are proper and secure. Clear all loose items removed
from area around the vehicle and turn ignition key ON to
test system.
Step 16: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not to
bind the harness wiring when reinstalling.
Step 17: Select parking grid line display option or
remove grid line display.
Grid line options: Default setting is to display grid
lines. To remove the grid line display, connect the
two green wires near the end of the camera
harness.
Green wires on the camera harness.
Finished exterior installation