Brandmotion 9002-8837 - Manual

INSTALLATION
INSTRUCTIONS
8837 Instructions 10-7-14.docx Page 1 of 6
Jeep Wrangler Rear Vision System for Factory Display Radios, 2007-Current
(Kit # 9002-8837)
Items Included in the Kit
Camera
Chassis Harness
Interior Harness
Program Module
Zip lock bag containing:
15 Wire Ties
Push Nuts
White 22-pin Radio Connector
These Instructions
Required Tools & Supplies
T15 & T20 Torx Bits
7mm & 10mm Sockets
Phillips Screwdriver
Plastic Trim Removal Tool
Soldering Iron, Solder, & Heat Shrink Tubing
(RECOMMENDED) or T-taps as an alternate
splicing method
Electrical Tape
Install Camera
Step 1: Loosen lug nuts to remove spare tire.
Step 2: Slide Camera on studs placing harness end
inside of tire carrier.
Step 3: Temporarily replace spare tire to check wheel
clearance to Camera.
Wheel Alignment for Camera Clearance
Step 4: Remove spare tire and slide (3) supplied Push
Nuts on the studs.