Brandmotion 1013-9550 - Manual

INSTALLATION
INSTRUCTIONS
9550 Instructions 1-8-13.doc Page 1 of 13
Rear Vision System – NAV Display
2007-Current Tahoe/Yukon/Suburban (Kit part number 1013-9550)
Kit Contents:
NAV Harness (shorter)
Chassis Harness (longer)
1 bubble bag containing Camera Mount
with camera and harness
1 bag containing:
12 Wire Ties
2 Rubber Well Nuts
2 Bolts
1 bag containing:
Ground Nut
ZTech (in a white bottle)
1 bag containing:
2 Templates (along with these instructions)
1 bag containing:
Jumper Harness with green wire
1 bag containing:
Denali Jumper Harness with pink wire
(use if required—see Step 29)
Tools Required:
T30 Torx Driver
7mm, 10mm, & 28mm Sockets
10mm Open-end Wrench
Pick
Push Pin Removal Tool
Delphi Terminal Tool 12094429 or Small
Flat Blade Watch Repair Screwdriver
Phillips Screwdriver
Plastic Trim Tool
Transfer Punch
1/8” & 5/16” Drill Bits
¾” Drill Bit or Center Hole Saw or Sheet
Metal Cutter
Power Drill
Deburring Tool
Electrical Tape
Digital Multimeter
Note: We strive to provide accurate and up-to-date installation instructions. For the latest full
color instructions, as well as an installation video, please visit www.brandmotion.com
IMPORTANT: Verify kit contents are complete against list above before beginning kit installation:
INSTALLATION
INSTRUCTIONS
Preparation
1. Ensure all lamps and accessories are OFF.
2. Ensure ignition switch is in the OFF position.
3. Loosen negative battery cable bolt. Remove
negative battery cable from terminal and position
away from battery.
4. Wait one (1) minute prior to working on the vehicle
to assure airbag system has been disabled for your
safety.