Brandmotion 1009-6503 - Manual

INSTALLATION
INSTRUCTIONS
6503 Instructions 2-4-14.Doc Page 1 of 8
Rear Vision System – Aftermarket and Factory 8.4” Touch Screen Display
(Factory Display requires Chrysler/Dodge dealer to activate)
2013 – Current Dodge Ram (Kit part number 1009-6503)
NOTE: Raising Reverse signal voltage using a Single Pull Dual Throw Relay is required when used with aftermarket
mirrors and displays. (Please refer to detailed installation steps on Page 7 of these instructions.)
Please read thoroughly before starting installation
and check that kit contents are complete.
Items Included in the Kit:
Chassis Harness with RCA*
Tailgate Handle with Camera
8.4” Factory Touch Screen Jumper
Harness
1 bag containing:
Plug for Non-Locking Tailgates (Optional)
Red wire with terminal for older vehicles (optional)
Black wire with terminal for older vehicles (optional)
1 bag containing:
These instructions
Template
*In some cases a RCA extension may be required
to connect to your aftermarket display; Kit#
9002-6111 may be purchased from
Brandmotion.com
Tools Required:
Socket Wrench with 7mm & 8mm Sockets
T20 and T30 Torx Bits
Phillips and Flat Blade Screwdrivers
Power Drill
1/8” Drill Bit
1” Hole Cutter
Pushpin Removal Tool
Round File or Deburring Tool
Center Punch
Utility Knife or Side Cutters
Masking Tape
Corrosion Inhibitor (recommended)
Soldering Iron & Solder (recommended)
Wire Ties (recommended)
We strive to provide accurate and up-to-date installation instructions.
For the latest full color instructions, please visit www.brandmotion.com
Install Tailgate Handle Camera
1. Set up a work area on which to set the tailgate after
removal. This area should be well protected to avoid
damage to tailgate.
2. Use your fingers to remove the black plastic filler
panel at rear of pickup bed adjacent to the license
plate. Press on the end tab and lifting outward.
Next, slide the red tab from the locked position and
unplug the tailgate power lock harness connector.
3. Unhook both tailgate support straps by inserting a
Flat Blade Screwdriver between the locking tab and
strap mount. Lift the locking tab away from the
strap mount with the screwdriver while sliding the
tailgate strap upwards. The tailgate strap hanger
can now be removed from the mount.
4. Open tailgate about ten degrees and lift right side of
the tailgate off the pin. Next, slide tailgate to the
right to remove taking care not to damage the paint.
NOTE: Tailgate removal and installation requires two
people.