Brandmotion 9002-7630 - Manual

INSTALLATION
INSTRUCTIONS
7630 Instructions 1-16-13.doc Page 1 of 4
Universal Dual Mount Camera Kit for Toyota Display Radio
(Kit part number 9002-7630)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit: Tools & Supplies Needed:
Bag containing:
Camera with License Plate Bracket
Chassis Harness
Jumper Harness
Small Zip Lock Bag containing:
Two License Plate Bolts
Allen Wrench
Alternate Camera Mount Bracket with
Adhesive Foam Pad
These Instructions with Template (below)
Phillips Screwdriver
10mm Socket
Center Punch
1/4’’ Drill Bit
Power Drill
Wire Ties
Electrical Tape or Heat Shrink Tubing
Plastic Trim Removal Tool
Soldering Iron & Solder
(Recommended)
Rubber Grommet or Silicone Caulk (Recommended)
Vehicle service manual (If needed)
Small sheet metal screws (Optional; recommended
for Alternative Camera Mount Bracket install)
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
Alternative
Camera Mount
Template