Brandmotion 1008-6509-V2 - Manual (Page 4)

6509 Instructions 5-22-12 Flex.doc 4 of 9
Section 2: Camera Installation
15. Test fit the camera mount in the factory
tailgate opening. If the camera mount does not
fit flush, determine where the mount is
contacting the edges of the opening and use a
flat metal file to enlarge it. Work slowly,
checking often for fit.
16. Clean the rough edges of the enlarged
opening with a deburring tool or round file.
17. Apply supplied Z-tech to any exposed bare
metal with a small brush (Figure 8).
Figure 8
18. Route the camera harness through liftgate
opening.
19. Using the two supplied 7mm screws, attach
camera mount to liftgate (Figure 9).
Figure 9
20. Route the light gray connector end of the
camera harness along the inner liftgate structure
toward the driver side of the liftgate opening
.